Hey all, having a really difficult time with the passenger side steering knuckle install. Drivers side went together perfect. Passenger side after everything is torqued the hole doesn't line up when torqued to 100. The nut seems like it has to go another full turn around to get the cotter pin through. I replaced with new dana Spicer ball joints.
I did notice after torqueing the lower ball stud to 85 that the ball stud on top was loose. Torqueing the split ring to 50 i noticed it goes down farther then the drivers side did. Any ideas?
Thanks for any input.
I did notice after torqueing the lower ball stud to 85 that the ball stud on top was loose. Torqueing the split ring to 50 i noticed it goes down farther then the drivers side did. Any ideas?
Thanks for any input.
0 commentaires:
Enregistrer un commentaire