Hi guys,
Found a quite cheap solution to read NAG1 trans temp and engine oil temp. But did not found a way to extract PIDs.
If you have autocom CDP+ or delphi DS150 VCI (100$, chinese resellers) and Wurth Wow 5.03 software, you login as an MB M class W164 you can log into the auto trans and get a lot infos.
If you use Delphi 2013.3 software with the same VCIs you can get into ESP/BAS controllers (wheel speeds, steer angle, yaw angle...)
Sadly no way to interact with FDCM (N23 reset!)
Of course with those two you can log into engine controller.
These VCIs can scan a lot of vehicles so not a bad investment.
Found a quite cheap solution to read NAG1 trans temp and engine oil temp. But did not found a way to extract PIDs.
If you have autocom CDP+ or delphi DS150 VCI (100$, chinese resellers) and Wurth Wow 5.03 software, you login as an MB M class W164 you can log into the auto trans and get a lot infos.
If you use Delphi 2013.3 software with the same VCIs you can get into ESP/BAS controllers (wheel speeds, steer angle, yaw angle...)
Sadly no way to interact with FDCM (N23 reset!)
Of course with those two you can log into engine controller.
These VCIs can scan a lot of vehicles so not a bad investment.
0 commentaires:
Enregistrer un commentaire