On the driver side there is a drain plug currently missing from the engine. I'm about to put the engine back in, but I need this plug. Any ideas what the size and thread pitch is? So far I tried a 3/8" NPT pipe plug, which is tapered. I can thread it in maybe a 1/2 turn before it binds... So I doubt the thread is right.
Just in case there is confusion, I found lots of threads on the square part, which was 8mm. But not an issue here as the plug is missing :).
Just in case there is confusion, I found lots of threads on the square part, which was 8mm. But not an issue here as the plug is missing :).
0 commentaires:
Enregistrer un commentaire