Intermittent ignition problem (no spark)

vendredi 12 septembre 2014

Tip: Intermittent ignition problem.

Problem: Won't start (no spark). Very intermittent.

Shortcut: Check voltage across ignition coil with ignition switch in "ON" position. If voltage is not 5 to 6 VDC, check ground wire connector to Ignition Control Module. If connector is ok (clean and tight) then ICM is faulty. ICM is located beneath the coolant reservoir on driver side of engine compartment. It is easily replaced after removing coolant reservoir.

Hope this helps someone out there. About drove me nuts trying to chase it down because it was so intermittent.

NellyBelle

1988 YJ

4.2 liter




Attached Images





File Type: jpg jeep ac.jpg (141.6 KB)






0 commentaires:

Enregistrer un commentaire

 

Lorem

Ipsum

Dolor