I bought a factory cruise control setup for my 2004 wrangler and installed it. The mechanical part was very easy. Unfortunately, I wasn't "pre-wired", so I had to add the overlay harness. The directions call for you to drill out 4 pin holes (4,5,11, and 32) on the ECM plug and insert wires from the new harness into them. I drilled 11 and 32 out, but 4 and 5 already had wires in them which I removed and inserted the wires from the the overlay harness. Long story short, when I started the jeep, the engine light came on, the gas gauge no longer works, and the volt meter is reading low. I didn't even take it for a test drive because I didn't want to get stranded. The cruise light did not come on when I pressed the on button. Does anyone have any idea what may be wrong?
Thanks,
Mark
Thanks,
Mark
0 commentaires:
Enregistrer un commentaire